Chipper Risk
Decision dossierEvidence reviewed
drum chipper

Rayco RC1522G Used Price & Common Problems

Rayco RC1522G: one used listing at $49,900. Documented problems: single infeed roller. What to inspect before you buy.

Status: published
Used range$49,900–$49,900
Recallnone found
Known risks3
Sources3
Verified2026-09-11
Buy-Risk Verdict
Inspect before buying · low confidence
Short answer: One observed used comp: 2017, 1,342 hrs, $49,900. Rayco chipper inventory is genuinely thin on the aggregators. Risks are drum-chipper class-level plus the single-infeed-roller design note (from the listing spec). Held as research. Used examples run about $49,900. Basis: Rayco RC1522G used listings.

Last verified against the primary source on Sep 11, 2026.

Decision status
inspect

One observed used comp: 2017, 1,342 hrs, $49,900. Rayco chipper inventory is genuinely thin on the aggregators. Risks are drum-chipper class-level plus the single-infeed-roller design note (from the listing spec). Held as research.

Confidence 40%
Market context
$49,900

1 observed comparables

As of Sep 11, 2026
Wear Component Timeline

What can make the cheap machine expensive?

ComponentSeverityDocumented repair cost
Single infeed rollermediumnot yet verified
Single infeed rollermedium

Spec confirms a single 20" infeed roller (vs dual on some competitors), the one roller carries all feed grip. Inspect for glazing and wear.

Cost not yet verified
Chipper knives (4-knife 30" drum)medium

Four knives on a 30" drum; verify edge and anvil condition. Class-level: dull knives raise load and vibration.

Cost not yet verified
GM 130 hp gas engine (hours)medium

1,342 hrs on a gas engine, verify compression and cooling. Gas (vs diesel) is less common on 15" chippers, a parts/fuel-cost note for buyers.

Cost not yet verified
Approximately 78% of the fatal chipper incidents involved the worker being drawn into the chipper.
— Hazards of Wood Chippers (SHIB 04-16-2008), accessed 2026-09-11

Common questions

How much does a used Rayco RC1522G cost?

We have one observed listing, at 49,900 (as of 2026-09-11). One listing is not a price range, so treat it as a single data point.

What fails on the Rayco RC1522G?

The most cited concerns in our evidence record: Single infeed roller. See the risk breakdown above for details and sources.

Evidence excerpts

From the research record

  • PRICE (THIN, 1 comp, SECONDARY, machinio, as-of 2026-09-11): 2017 $49,900 Charlotte NC (listing 103874550, GM 130hp gas, 15"×22" throat, 4-knife 30" drum, single 20" infeed roller, 1342 hrs). Rayco chipper inventory is genuinely thin on the aggregators.
  • SAFETY (PRIMARY, OSHA SHIB 04-16-2008): 15-inch infeed = high caught-in energy; feed/panic/bottom-stop bars, hood latch, LOTO.
Reference list

Sources

  1. Rayco RC1522G used listingsweb · research-cited · accessed 2026-09-11
  2. Hazards of Wood Chippers (SHIB 04-16-2008)official · verified-official · accessed 2026-09-11
  3. 2017 Rayco RC1522G in Charlotte, NCweb · research-cited · accessed 2026-09-11
Spot an error? Challenge this record

Found an out-of-date code section, a wrong verdict, or a better primary source? Tell us. Corrections that check out are applied, with the change shown in history. That is our standing policy.